Sivun sisältöön

Splitter Cable

  • Distributes a power supply connection to two pedals
  • The white striped cable is ungrounded to avoid ground loops
  • PSU connector 2.1mm coaxial
  • Pedal connector: 2 x 2.1 mm coaxial
  • Polarity: Standard (center minus)
  • Length: 10 cm
  • Myynnissä vuodesta Elokuu 2012
  • Tuotenumero 292968
  • Myyntierä 1 kappaletta
11 €
Kaikki hinnat sis. ALV:n
Varastossa
1

312 Asiakkaiden arviot

4.7 / 5

Työnjälki

122 Arvostelut

A
Erittäin hyödyllinen apuväline
Tuntematon 21.06.2016
Näillä output splittereillä saa tavallisesta Voodoo Labin virtalähteestä paljon enemmän irti. Itse käytän näitä Voodoo Labin Pedal Power Plus -virtalähteessä ja saan näiden avulla virroitettua kahdeksasta lähteestä 16 (!) pedaalia. 8 ulostulosta 6 on 100mA lähtö ja kahdessa suurempi. Useimmat pedaalit kuitenkin vievät vain 5-70 mA, joten huolellisesti suunnittelemalla virran syötön näiden avulla saa pienestäkin virtalähteestä suuren määrän pedaaleita virroitettua. Nämä ei aiheuta minkäänlaista maalenkkiä, josta tulisi lisähurinoita. Suosittelen.
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

m
Yksi virransyöttö kahdeksi
muskari 24.01.2018
Näppärä ratkaisu, jolla samasta lähteestä voi antaa virtaa kahdelle eri pedaalille. Ei hurinoita, ei mitään epäilyttävää. Erinomainen tuote.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

P
PPJPM 29.06.2026
I've owned about 10 of these over the years. They do their job and provide noiseless operation. However, for some reason I've had many of them suddenly stop working. One of the cables is marked with white and it is always that one which stops working. Some I've had for years without problems, but there's always the fear of them dying at a critical situation, like when you're on stage. I recommend always having a back up splitter for a quick fix before all goes wrong.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
MJ
Splitter splits like it's supposed to
Mick Jansen 23.01.2019
I bought this splitter after I needed another powersource for my new pedal. My Fuel Tank Junior only had five outputs of 120mA, 9V each. Like I said, I got myself a new pedal which was number six on the board. I figured that I could split the current of one of the outputs and share the current over two low current drawing pedals. Both pedals needed 40mA each, so splitting the 120mA would be a good solution.
I came across this splitter and it seemed to be the one I needed. You really need to carefully read the description of the splitter you are purchasing, because some are designed to split the voltage or even double the voltage. Make sure to choose the right one.
This cable is working fine in my setup. One of the splitters end has a white stripe to indicate that it is groundlifted (to make sure there is no buzz of hum when using it). My signal stayed perfectly quiet so I assume it's doing it's job. I experienced no cons so far.
Työnjälki
3
0
Raportoi ongelmasta

Raportoi ongelmasta