ST
A bit thin and bends easily
I was a little surprised of the thinness of this plate. Approximately only 1.5 mm. The neckplate is probably supposed to be used with black plastic/rubber underplate as is the case with 70's Fender guitars and basses. I guess that is the reason for thinness. Otherwise the neckplate assembly would become a bit bulky. But true to '70s vintage the neckplates probably were this thin.
It naturally works without it, but I found out it bent easily as I tightened the screws (which by the way were of very high quality).
I doubt the thinness does anything noticeable to sustain or overall sound of the instrument. The plate acts as a simple washer would and is only there to give support to the screws.
If you are looking for a sturdier neckplate I would recommend the Corona Neckplate.
It naturally works without it, but I found out it bent easily as I tightened the screws (which by the way were of very high quality).
I doubt the thinness does anything noticeable to sustain or overall sound of the instrument. The plate acts as a simple washer would and is only there to give support to the screws.
If you are looking for a sturdier neckplate I would recommend the Corona Neckplate.
0
0
Raportoi ongelmasta
P
Järkiosa pikkuhintaan
Tämä ei toki muuta soitinta kuin ulkoisesti, mutta sekin on tärkeää. F-logo näyttää hyvälle, pimp your guitar , you are worth it :)
Hyvää:
Sopi vanhan tilalle , siisti kromaus ja hyvät ruuvit.
Huonoa ei ole
Hyvää:
Sopi vanhan tilalle , siisti kromaus ja hyvät ruuvit.
Huonoa ei ole
0
0
Raportoi ongelmasta
J
Taattua Fenderin laatua. Suomesta Tampereelta ei löytynyt mistään musiikkiliikkeesta tällaista osaa, missä on F-merkki, tai lukee Fender.
0
0
Raportoi ongelmasta
R
Tyytyväinen!
Hyvä laatu!
0
0
Raportoi ongelmasta
A
Fender Neck Plate
Big "F" Peukkua. Istuu, kuin hirvi...
0
0
Raportoi ongelmasta