Roland BT-1 Bar Trigger Pad

()

Näytä käännös

Compact Single-Trigger Pad

Curved design for mounting on the V-Pad or acoustic drum
Quick and easy mounting
Including fittings for the L-Rod bracket
Compatible with any V-Drums module or SPD series for triggering sounds or control functions such as start/stop, loops, playbacks, effects on/off, kit selection, tap tempo and more
Interior dimensions (W x D x H): 170 x 53 x 60 mm
Weight: 300 g
Includes 6 mm stereo cable (2.5 m)

30 päivän palautusoikeus

3 vuoden Thomann-takuu

Myynnissä vuodesta Helmikuu 2013
Tuotenumero 305277
Myyntierä 1 kappaletta
Type Of Trigger Universal Trigger
Mesh Head Pads Yes

133 €

Kaikki hinnat sis. ALV:n

Myyntisijoitus

kategoriassa Triggerit

Näitä ostavat asiakkaat, jotka ovat tutkineet tätä tuotetta.

81%

Ostettu

Täsmälleen tämä tuote

133 €

Ostettu

Roland PD-8 V-Drum Stereo Rubber Pad

103 €

Ostettu

Millenium MPS-850 08" Mesh Head Pad

66 €

Ostettu

Roland PDX-100 10" V-Drum Pad

222 €

Ostettu

Millenium MPS-850 10" Mesh Head Pad

81 €

163 Asiakkaiden arviot

5 116 Asiakkaat 4 38 Asiakkaat 3 7 Asiakkaat 2 2 Asiakkaat 1 0 Asiakkaat

4.6 / 5

Työnjälki

Triggaus

Arvosteluohjeet

83 Arvostelut

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

Nice compact trigger. Nice idea but not well excecuted.

NickKorobo 26.03.2020

This is a compact trigger which you can squeeze close to other drums or cymbals. And now the cons:
- Personally I could not mount it on the rods of my acoustic drums as it is advertised so sadly I used separate mounts.
- Although this is basically a mono trigger, it uses and requires a stereo cable. So it will cover a stereo input in your e-drums brain just to be used as a mono. Y-cables are useless.
- It is not the most sensitive trigger.
- Installation on a mount has to be on the top tip of the mount otherwise the protruding steel bar of your mount lies in the middle and is frequently hit by your drum sticks.
- Expensive for a mono trigger.
- Tightening lug spiral is from plastic. If you tight the lug relatively hard, you risk damaging the spiral so the screw will not be secure any more.

The general idea was great but the execution is really poor. I would recommend it only for how small it is.

Raportoi ongelmasta

Uskotko, että tämä arvostelu on epätarkka tai hyväksymätön jostain syystä? Ole hyvä ja kirjoita syy tekstikenttään ja – jos mahdollista – anna mukaan sähköpostiosoitteesi mahdollisia kysymyksiämme varten.

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

Good but not perfect

Myles 13.08.2015

Firstly the Good: this is a great idea and it is a very well made peice of kit. It's robust and definaty suited to giging drummer who want to either expand the playing surfaces on the electronic kit, or want to incorprate it as part of a hybrid solution. I do both. I use one on my Roland TD20 kit and I use two on my accoustic kit via a Roland TM2.

Now the Not So Perfect: this trigger fits very well onto Roland V Drums, however I've use on two differnt accoustic kits (Gretsch and a DW) on floor tom and snare, and in both cases the fit is less than perfect. The BT-1 comes with spacing adapters, but these didn't really help.
Also this is a single trigger surface, so in principal it should only need a mono jack lead, however it only works with a stereo jack which is provided. Whs is this an issue you ask...? Well on the TM2 Roland Trigger Module, you can split each stereo input - of which there are two - into monos using a 1 x stereo - 2 x mono Y cable, therefore allwing you to have four triggers instead of two.

Raportoi ongelmasta

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

Hybrid drumming

Christian1362 21.01.2015

I use two BT-1 and RT for kick and snare through a TM-2 module. That gives me really good punch in my acoustic Pearl MCX. I can use a 20" and add that extra bottom with the TM-2 through our PA. The snare can get some additional crack and reverb sounds. The BT-1 have often tamburine and x-stick, handclap or cowbel assigned. All triggers have excellent respons and build quality. Over the years I tested several different types of triggers but I have to say that Rolands are the best. Easy to install of course as TM-2 is made for them.

Raportoi ongelmasta

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

High-quality pad with a quirk

Alisher Moldabekov 25.06.2024

I was eyeing the Roland BT-1 for a long time and watched many YouTube videos about it before finally deciding to buy it. The result left me with mixed impressions.

Pros: The pad is made of very high-quality and durable materials and will probably last for decades with proper care. The trigger responds quite well and accurately, and there is velocity sensitivity. You can attach this pad to the rim of a snare drum or another Roland pad. I have a Roland TD-27 and I attached the BT-1 to the Roland PD-140 DS snare drum.

Cons: When attaching this pad to the rim of the drum, the BT-1 picks up hits on the snare drum and triggers a double hit. This can be adjusted in the module, but it won't be easy for beginners to do.

Overall, this is an excellent pad and will work best if it is not mounted on the rim of the drum but on a separate clamp or cymbal stand.

Raportoi ongelmasta

Lue kaikki arvostelut

Roland BT-1 Bar Trigger Pad

Compact Single-Trigger Pad

Näitä ostavat asiakkaat, jotka ovat tutkineet tätä tuotetta.

163 Asiakkaiden arviot

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

83 Arvostelut

Smart Navigator

Paras mahdollinen ostokokemus!

Roland BT-1 Bar Trigger Pad

Compact Single-Trigger Pad

Näitä ostavat asiakkaat, jotka ovat tutkineet tätä tuotetta.

Lisävarusteet ja yhteensopivat tuotteet

163 Asiakkaiden arviot

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

83 Arvostelut

Vertaile vaihtoehtoa

Smart Navigator