L
Great for patch cables
Extremely small plugs that are very easy to solder and great to make custom jacks. especially great to make small patch cables for pedalboard.
1
0
Raportoi ongelmasta
L
Spacing is perfect and super good value.
These jacks are pretty much perfect for my build! The way the plug is designed allows for cables to be run spaced super close to each other, allowing me to space pedals so much closer together. They also allow me to make full use of my multifx by being able to plug into multiple jacks which are right next to each other without worrying about clamping forces or damaging the pedal or cable. They are quite easy to solder as well, since there is a layer of paper to prevent shorts between Tip and ground. I found it was a bit difficult to tin the housing, so for some I wedged some ground wire between the housing pieces and clamped it with screws, which may not be the best solution but it works. Would buy again, I got 16 for my pedalboard!
0
0
Raportoi ongelmasta
EC
Good enought
I bought it for the pedalboard.
+ the quality is excellent
- too big for stereo pedals
Look up the specs online before you buy.
+ the quality is excellent
- too big for stereo pedals
Look up the specs online before you buy.
4
0
Raportoi ongelmasta
B
Don’t like the crimping mechanism, but good connector.
I understand that it is pancake style but, the way it hold the cable is not great. I wouldn’t trust it in an instrument cable. If you use slightly thinner cables than the standard instrument wire, it slips. Such a shame.
2
0
Raportoi ongelmasta
A
REAN RP2RCF
A great budget alternative to expensive squareplu connestors. They are just a little thicker, much cheaper but great quality.
I'm surprised I don't see the used more often, Highly recomended.
I'm surprised I don't see the used more often, Highly recomended.
0
0
Raportoi ongelmasta
D
This is a top chioce if you need a compact angled jack
I've bought many of theese to make custom patch cables for my pedalboard. I hade zero issues with them. These are as good as similar but much more expensive ones. If you don't need the absolute most compact angled jack, then you should buy this with confidence. I think these are compact too, but there might be certain situations when these would be like 1 mm too big.
0
0
Raportoi ongelmasta
JM
Great for pedalboards
Excellent for making pedalboards.
Screw on cap makes it very quick access and the plugs are much easier to solder onto than a Neutrik right angled cable
Screw on cap makes it very quick access and the plugs are much easier to solder onto than a Neutrik right angled cable
0
0
Raportoi ongelmasta
B
Great build quality
Solid build, very similar to square plug just slightly more depth sticking out of pedal like a few mm. The built in strain relief is a bit too wide for 4mm cable and would likely fit 5.5 to 6mm cable better
0
0
Raportoi ongelmasta
EO
Good value for money
I always thought pancake-ish plugs were too expensive. These are great! A little fatter than your standard pancake plug, but looks the part. Make sure you use a fat cable for these, as the cable hole is rather wide.
0
0
Raportoi ongelmasta
A
Perfect for pedal boards
Bought a few pairs of this connector to tidy up my pedal board and they are great, good fit with nicely sized solder pads inside. I've had no issues with the connectors!
0
0
Raportoi ongelmasta