EY
Doesn't fit a Mexican Fender Player Telecaster
You have to check if it fits yours, since it only fits standard Telecasters. On my case it didn't, and basically what I had to do was, grid the wooden plate cavity of the guitar's body a little bit (so the knobs fit), and also, drill a new screw hole.
I will probably create a reddit post regarding this. You have to start by positioning the side of the plate closer to the neck. That will be your baseline to make it fit.
The hole that has to be redone is the one closer to the bridge, not to the neck.
Other than that, I am extremely happy with the quality. The base player telecaster control plate is really bad quality, you will see it when you pull it out :D
I will probably create a reddit post regarding this. You have to start by positioning the side of the plate closer to the neck. That will be your baseline to make it fit.
The hole that has to be redone is the one closer to the bridge, not to the neck.
Other than that, I am extremely happy with the quality. The base player telecaster control plate is really bad quality, you will see it when you pull it out :D
0
0
Raportoi ongelmasta