JJ
Too tall for flat tops
This product is a bit too tall for normal flat top guitars, like my custom Explorer, the pickup has to be flush to the pickup frame so it doesn't touch the strings.
I replaced it after a few months.
The neck frame is perfect.
I replaced it after a few months.
The neck frame is perfect.
1
0
Raportoi ongelmasta
V
Great!
Was looking for this weird spacing and here I found it. I think the Goldo frame is exactly the same product (from the same factory in Korea) but twice the price so what's not to like about this HB frame!
1
0
Raportoi ongelmasta
d
Fits Epiphone Les Paul Slash AFD Special II perfctly
Had no issues fitting this to my Les Paul.
0
0
Raportoi ongelmasta
TG
These are slightly narrower than most common rings, which was exactly what I was looking for. I replaced the originals of my early 2000's LTD Viper and they were identical, same manufacturers part number stamped on the inside. All the spares I had were slightly wider which would have caused issues lining up the screws with the existing holes.
0
0
Raportoi ongelmasta
Ra
If it fits...
... can't wrong with something that either fits or doesn't. There is certainly no sonic differences between this affordable pick-up ring and a more expensive one. The humbucker size is standard. and if the screws that holds it are slightly off, the new holes would be invisible. Recommended.
0
0
Raportoi ongelmasta
A
Harley Benton Hu Frame
This works as should and fit normal holes. Remember - if your guitar currently has two same size rings you will need to order longer screws to fit this!! One other note - this is tapered on the bottom so one end sits higher than the other!
0
0
Raportoi ongelmasta
T
does what it supposed to
As good as any other Frames I have bought so far.
I cannot see any difference to more expensive frames I have bought in the past.
I cannot see any difference to more expensive frames I have bought in the past.
0
0
Raportoi ongelmasta
D
Quality mount ring
My ring was taller than the one I replaced. I may have ordered the wrong part. I kept it for a backup ring mount as it is nice quality.
0
0
Raportoi ongelmasta
im
overall great
I don't think that the quality could get any better, anyway you look it , it's just a pickup frame.
The demensions are mentioned BUT its pretty high and perhaps the strings could colid with it. I'd suggest you just buy 2 frames for the neck and they should do fine!
The demensions are mentioned BUT its pretty high and perhaps the strings could colid with it. I'd suggest you just buy 2 frames for the neck and they should do fine!
0
0
Raportoi ongelmasta
M
Quite high
You can't fault these as far as build quality is concerned. However, if you have a Floyd rose bridge, this will force your action to be higher than desired. Go for 2 neck frames if you have a Floyd rose. Apart from that there is absolutely nothing wrong with these!
0
0
Raportoi ongelmasta