Göldo Balance Poti 250

()

Aloita 360°

Näytä käännös

Balance Control for Electric Guitar / Electric Bass

Two 125 kOhm in parallel
Suitable for two single coil pickups
Both pickups are fully active in the middle position - no loss of sound or volume
Small size
Thread: M10 x 7 mm
Housing: Ø 17 mm
Smooth shaft
Including nut and washer

Myynnissä vuodesta Elokuu 2014
Tuotenumero 346141
Myyntierä 1 kappaletta
Design Tandem
Resistance Value 2x 125 kOhm
Characteristic Curve none
Thread Length in mm 10,0 mm
Tandem Poti Yes
Push/Push No
Solderless No
shaft type Smooth

15,90 €

Kaikki hinnat sis. ALV:n

130

Myyntisijoitus

kategoriassa Potentiometrit

Näitä ostavat asiakkaat, jotka ovat tutkineet tätä tuotetta.

42%

Ostettu

Täsmälleen tämä tuote

15,90 €

Ostettu

Göldo True Panorama Pot

9,60 €

Ostettu

Allparts CTS 500K Audio Taper Pot

9,90 €

Ostettu

Allparts CTS 250K 9,5 Spl Aud.Taper Pot

9,90 €

Ostettu

Göldo 250K Std. Split AT Pot

4,77 €

81 Asiakkaiden arviot

5 70 Asiakkaat 4 7 Asiakkaat 3 3 Asiakkaat 2 1 Asiakas 1 0 Asiakkaat

4.8 / 5

Työnjälki

Arvosteluohjeet

47 Arvostelut

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

The BLEND pot you're looking for

Kyuuga 01.08.2018

I purchased this pot because I wanted to change my Jazz bass from V/V/T to V/B/T.

This is the pot you're looking for if you want to do the same thing. There's a detent in the middle so that you can feel when it's halfway and when it is you get BOTH pickups full on. There's also a decent margin either way so that you can mix and match both tones.

Overall a very solid blend pot and if you're looking to replace yours or purchase a new one for a different control setup on your bass this is the one you want.

Raportoi ongelmasta

Uskotko, että tämä arvostelu on epätarkka tai hyväksymätön jostain syystä? Ole hyvä ja kirjoita syy tekstikenttään ja – jos mahdollista – anna mukaan sähköpostiosoitteesi mahdollisia kysymyksiämme varten.

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

Good blender pot, but a bit tricky to solder.

AshS 10.12.2022

I bought this pot for a 2 pickup (P/J) bass project, after first trying a 1960 concentric/stacked knob setup and being disappointed by the drops in volume and tone and troubles when the pickups weren’t fully open (common loading issues on 2 pickup passive basses). I decided to try a blend pot instead and I must admit it’s a fantastic option if one wants to be able to blend between the pickups. The resulting control layout is quite easy to use and musically inspiring with a full spectrum of tones available. This specific blend pot feels great, and has a nice center detent where both pickups are on. Only issue I had was when soldering the electronics - since the tiny PCB has inputs very close to one another and it was actually way more of a pain to get things in place without solder shorting - compared to more traditional potentiometers. There was a bit of plastic melting and just in general needs more care and control. Not a deal breaker, as it all worked perfectly once installed, but it took a bit more effort than I would have liked.

Raportoi ongelmasta

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

Balance pot with a bump in the middle

SouledOut 18.08.2022

This is the pot for people who want a blend pot that doesn't have volume loss when using both pickups at max volume and a bump in the middle to know your in the middle. Classic blend pots have a volume loss in the middle position so that's not going to work for me.
How I used it:
I have a PJ bass so 1 prec pickup and 1 jazz pickup. Classic wiring would be to have 2 volume pots ( 1 for each pickup) and a master tone pot.
I wired mine to have a master volume, master tone and used this pot as a blend.

If you ask me this is perfect for blend, in the middle you get both pickups at max and then when you go left or right you get more of the pickup you want.

I only gave it 4 stars for quality because I don't know how will it last, time will tell.

Raportoi ongelmasta

Näytä käännös

Näytä alkuperäinen

Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.

Excellent

Tuntematon 27.10.2015

I use this for my guitar, replacing one of the volume pots. Then the signal goes to the remaining volume pot, which now serves the mix from both pickups, and then on to the tone pot. Much more convenient for adjusting while playing.

Soldering was a challenge, as the space inside my guitar is very small, and so is this pot.

Excellent pot with a good feeling for the travel between end points and the dent for middle position, and with clear instructons for wiring.

I would have preferred this pot with a shorter and knurled shaft, though.

Raportoi ongelmasta

Lue kaikki arvostelut

Göldo Balance Poti 250

Balance Control for Electric Guitar / Electric Bass

Näitä ostavat asiakkaat, jotka ovat tutkineet tätä tuotetta.

81 Asiakkaiden arviot

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

47 Arvostelut

Smart Navigator

Paras mahdollinen ostokokemus!

Göldo Balance Poti 250

Balance Control for Electric Guitar / Electric Bass

Näitä ostavat asiakkaat, jotka ovat tutkineet tätä tuotetta.

Lisävarusteet ja yhteensopivat tuotteet

81 Asiakkaiden arviot

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

47 Arvostelut

Vertaile vaihtoehtoa

Smart Navigator